The high-density, ceramic-based
thermal compound specifically designed for modern high-power Peltier
Elements and high-performance heatsinks or water-cooling solutions.
Made with micronized aluminum oxide, boron nitride and zinc oxide.“Ceramique”
uses a high-density layered composite of five unique shapes of thermally
conductive alumi-num oxide, boron nitride and zinc oxide sub-micron
particles to maximize particle-to-particle contact area and thermal
This exclusive combination provides performance exceeding most metal
Average particle size: 0.38 µm <0.000015 inch
Controlled triple phase viscosity.
“Ceramique” does not contain any silicone. The suspension
fluid is a proprietary mixture of advanced polysynthetic oils that provide
superior performance and long-term stability.
During the system's initial use, the heat from the Peltier Elements
lowers the viscosity of the compound to enhance the filling of the microscopic
valleys and ensure a minimum bond line between the heatsink and the
Peltier Element core. Then the compound thickens slightly over the next
100 to 300 hours of use to its final consistency designed for long-term
(This should not be confused with conventional phase change pads that
are pre-attached to many heat-sinks. Those pads melt each time they
get hot then re-solidify when they cool. The viscosity changes that
Ceramique goes through are much more subtle and ultimately much more
“Ceramique” is engineered to not separate, run, migrate,
“Ceramique” does not contain any metal or other electrically
conductive materials. It is a pure electrical insulator, neither electrically
conductive nor capacitive.
Wide Temperature Limits.
Peak: – 40°C to > +180°C
Long-Term: – 40°C to +140°C
Easy Clean Up.
“Ceramique” can easily be cleaned from Peltier Elements
and heatsinks with isopropyl alcohol or any of the cleaners listed in
the product instructions.
The 2.7-gram “Ceramique” is the first product available
in our proprietary thermal compound syringe. Our new syringe is more
compact, easier to handle and dispenses a higher percentage of its content
than standard industrial or medical syringes. The amount of compound
remaining in the syringe is easy to determine as the rear of the plunger
is perfectly flush with the flange when the syringe is empty.
Syringes with 2 ml, 4 ml, 8 ml, 16 ml also are available.